Hello Admin wizwards,
Michael James Bradford pointed out that in the example supplied by Bard
Tesaker the partition /dev/rz0c was to be added, which would represent
the whole disk.
I would like to point out that of course everyone has to replace it with
the letter representing the disk partition in question (in my case it
was /dev/rz0h).
Thank you, Michael!
CW
once again thanks for all the answers and a big hand for:
Tom Blinn (!), Bl Venkatesh, Bard Tesaker, Peter Stern, Armin Olig
Consensus was that:
a) quota files MUST not be deleted cause they are used by the AdvFS;
they are however only sparse files so that most of the pages are nopt
really there (Tom)
b) it is highly recommended NOT to resize the disk partition (eg
/dev/rz0h) w/ diskconfig while the system is running.
c) However the following way proved to be useful for the main
clusternode (and failed on the failover node for obscure reasons): use
disklabel to mark the partition h as used by advfs and use addvol to add
it as a volume to the filedomain usr_domain. Bard Tesaker supplied
this procedure:
#######################################################################
Example under assumes the system disk /dev/rz0 (rawdevice /dev/rrz0)
and "ed" as EDITOR.
* First edit the disklabel so the h partition covers the unused blocks:
#stamme:/> disklabel -re /dev/rrz0c
1068
/ h:
h: 0 0 unused 0 0 # (Cyl. 0 - -1)
s/0/135143/
s/0/1817930/
-1
h: 135143 1817930 unused 0 0 # (Cyl. 0 - -1)
w
1079
q
write new label? [y]: y
re-edit the label? [y]: n
#stamme:/>
* Then add the h partition to the usr_domain (require advfs licence)
#stamme:/> addvol /dev/rz0c usr_domain
#stamme:/>
"df /usr" and "showfdmn usr_domain" should now reflect the change.
/etc/usr_domain should contain rz0g and rz0h.
This procedure should be "tamper-safe" since both disklabel and addvol
verifies that your actions are safe, checking overlap with acive
partitions etc.
##########################################################
d) workaround on the failover cluster: I created the partition h as
described and also created a new domain (var_domain) and a fset (var) on
it. Then, i edited fstab to mount this new partition as /var and moved
the complete content of /var (i.e. /usr/var) to it.
thank you all!!
CW
Received on Tue Jan 17 2006 - 07:57:24 NZDT