If you have upgraded a disk in a volume shadowing environment,
you must now re-form the shadow set. If you want to form a shadow
set for a newly installed system disk, you can do this now or later.
To do so requires that the VOLSHAD license has been entered and
loaded. In addition, you must set several system parameters, as
explained in “Set System Parameters for Volume Shadowing
(New Installations Only; Optional)”,
and then you must run AUTOGEN and reboot the system, as explained
in “Running AUTOGEN to Set System Parameter Changes”.
Forming the shadow set with the newly installed or upgraded
disk as the master causes the other disks in the shadow set to be
updated with a copy of the disk. (In a single-member shadow set,
although no other disks exist to be updated, the shadow set can
be used to facilitate replacement of a failed drive.)
After forming the shadow set, you can then dismount one of
the shadow set members and keep it as a backup. After you perform
the steps recommended in this chapter, you can place another volume
into the shadow set instead of doing the final backup, or re-add
the volume that was dismounted.
Form the shadow set as follows:
Enter the SHOW DEVICE D command to display
a list of disks available on your system. For example:
$ SHOW DEVICE D Device Device Error Volume Free Trans Mnt Name Status Count Label Blocks Count Cnt $11$DKB100: (NODE1) Online 0 $11$DKB200: (NODE1) Mounted 0 I64083 918150 1 31
DSAn: is the
virtual unit name of the shadow set, where n is
a unique number from 0 to 999.
upgraded-disk: is the name
of the shadowed system disk on which you just upgraded or installed
OpenVMS.
new-member: is the name of
the disk you want to add as a member of the shadow set.
volume-label is the volume
label of the shadow set you just upgraded or the disk you are creating.
NOTE: When you form the shadow set, the contents of the new
member are replaced by the contents of the disk you upgraded. Specifying
the /CONFIRM qualifier reminds you of this fact, confirming that
you are specifying the correct name of a disk that either is blank
or contains files you no longer need.
%MOUNT-F-SHDWCOPYREQ, shadow copy required Virtual Unit - DSA54 Volume label I64A083 Member Volume label Owner UIC $11$DKB100: (NODE1) SCRATCH [100,100] Allow FULL shadow copy on the above member(s)? [N]: YES
NOTE: Before continuing with the next step in this chapter,
after the shadow copy completes, dismount one of the shadow set
members to use as a backup. Normally, this should be the unit you
just added to the upgraded volume when you formed the shadow set
(in the preceding example, $11$DKB100:).
For OpenVMS I64, to add a shadowed system disk in a multiple-member
shadow set to the EFI boot device list and dump device list, HP
recommends using the OpenVMS I64 Boot Manager utility (SYS$MANAGER:BOOT_OPTIONS.COM).
Be sure to add all members to both lists.
