Hi all,
I have a QIC-150 external tape unit that does not respond no more.
It worked fine untill I done something unadvertantly. The tape unit was set
with SCSI ID=4, i recently got a RZ28 disk to fit into a StorageWorks
box which I plugged into the last slot in the StorageWorks box. At this point
I did not check the SCSI ID for the slot which happened to be 4. After booting
up, the system could see the RZ28 disk as ID=4. Comming to use the QIC-150 tape,
a week later it did'nt work - setting the SCSI-ID to 5 or 6 it fails to work
anymore ( the system does not pick it up using 'show device' ).
Could this of damaged the QIC-150 controller somehow ?
At the time this happened I also had a TLZ07 dat tape set to SCSI-ID=5, it was
not affected and continues to work fine.
Any help or suggestions are greatly appreciated.
Joe
+-----------------------------------------------------------------------------+
| |
| Joe Spanicek |
| /\/\ Research Officer |
| / / /\ Process Engineering R & D |
| / / / \ |
| / / / /\ \ BHP Research - Port Kembla Labs |
| \ \/ / / / P.O Box 77, Port Kembla, NSW Australia 2505 |
| \ / / / Fax: +61 (42) 756120 (reception at BHP Research) |
| \/\/\/ Tel: +61 (42) 756148 (reception at BHP Research) |
| Direct Fax: +61 (42) 756524 (Current location) |
| Direct Tel: +61 (42) 756111 Ext: 4502 (Current location) |
| Email: joe_at_resptk.bhp.com.au |
| |
+-----------------------------------------------------------------------------+
Received on Thu Apr 13 1995 - 02:58:54 NZST