>
> I'm attempting to upgrade my Alpha 3000/300LX's firmware but I am unable
> to issue the following command to boot from the cdrom:
>
> >>> b -fl 0,80 dka600
>
> ?UNK CMD
>
> >>> b -fl i
>
> same response...
>
> I am thinking that one of my settings is wrong?
> Any suggestions, directions, or comments are always appreciated.
>
Sorry, I didn't post enough information. I've tried
>>> BOOT -FL 0,80 DKA600
?23 ILL CMD
>>> boot -fl 0,80 dka600
?23 ILL CMD
This seems trival but I'm getting fairly fustrated. I really
don't understand why I can't boot the cdrom.
>>> show
AUTO_ACTION = HALT
BOOTDEF_DEV = DKA300
BOOT_OSFLAGS = 0,A
ENABLE_AUDIT = OFF
BOOT_RESET = ON
SCSI_RESET = 6
DIAG_LOE = OFF
DIAG_QUICK = OFF
DIAG_SECTION = 1
LANGUAGE = 3
ETHERNET = ....
MOP = ON
SECURE = ON
RADIX = 0
SCSI_A = 7
TRIGGER = OFF
thanks,
Greg
Greg Siekas
Department of Biomedical Engineering
Tulane University
email: siekas_at_mailhost.tcs.tulane.edu
url:
http://tatanka.bmen.tulane.edu/~siekas
Received on Sat Jul 22 1995 - 01:04:00 NZST