I'm looking to turn the following information from Seagate into a disktab
entry for Digital Unix V3.2. If anyone's done this before, I'd appreciate the
assistance. Thanks.
ST-41200N
94601-12G/M WREN 7 FH
UNFORMATTED CAPACITY (MB) ________________1.2G
FORMATTED CAPACITY (xx SECTORS) (MB) _____1037
AVERAGE SECTORS PER TRACK ________________71
ACTUATOR TYPE ____________________________VOICE COIL
TRACKS ___________________________________28965
CYLINDERS ________________________________1931
HEADS ____________________________________15
DISCS ____________________________________8
MEDIA TYPE _______________________________THIN FILM
RECORDING METHOD _________________________ZBR RLL (1,7)
TRANSFER RATE (mbytes/sec) _______________1.875-2.875
SPINDLE SPEED (RPM) ______________________3,600
AVERAGE LATENCY (mSEC) ___________________8.33
BUFFER ___________________________________256 Kbyte
SCSI-1: Read Look-Ahead, Non_Adaptive,
Single-Segmented Buffer
SCSI-2: Read Look-Ahead, Adaptive,
Multi-Segmented Cache
INTERFACE ________________________________SCSI-2
TPI (TRACKS PER INCH) ____________________1600
BPI (BITS PER INCH) ______________________32750
AVERAGE ACCESS (ms) ______________________15
SINGLE TRACK SEEK (ms) ___________________2.5
MAX FULL SEEK (ms) _______________________34
MTBF (power-on hours) ____________________150,000
POWER REQUIREMENTS: +12V START-UP (amps) _4.5
+12V TYPICAL (amps) __1.6
+5V START-UP (amps) __1.1
+5V TYPICAL (amps) ___0.8
TYPICAL (watts) ______24
MAXIMUM (watts) ______60
BUFFERED STEP PULSE RATE (micro sec) _____
WRITE PRECOMP (cyl) ______________________N/A
REDUCED WRITE CURRENT (cyl) ______________N/A
LANDING ZONE (cyl) _______________________AUTO PARK
IBM AT DRIVE TYPE ________________________0 or NONE
ZBR = Zone Bit Recording = Variable sectors per track
Already low-level formatted at the factory.
-Jeff E. Nelson / Apertus Technologies Corporation / System Management Group
-Internet: jeff.nelson_at_apertus.com
Received on Fri Jan 12 1996 - 17:04:58 NZDT