Hello. I have an 8200 with 3 HSZ40's hanging off of 3 KZPSA's. The
HSZ40's have 6, 4, and 2 stripe sets (respectively) hanging off of
them. Each stripe set is 20GB. Here's the deal: The default kernel
built when the system is installed only picks up device 0 on each
HSZ40. I need to see all 12 20Gb stripe sets. How do I add the lines
to my /usr/sys/conf/BLAH file to pick them up? They stripe sets aren't
LUNS of one ID, I don't think. The manual isn't explicit on what to do
if you have stripe sets. Every other configuration is covered, but not
stripe sets. Help? What are the proper device numbers in the /dev
directory, too?
Here are the default lines from the kernel config file:
** start **
bus isp0 at pci0 slot 0 vector ispintr
controller scsi0 at isp0 slot 0
device disk rz1 at scsi0 drive 8
bus isp1 at pci0 slot 1 vector ispintr
controller scsi1 at isp1 slot 0
device disk rz10 at scsi1 drive 80
bus isp2 at pci0 slot 4 vector ispintr
controller scsi2 at isp2 slot 0
device disk rz19 at scsi2 drive 152
** end **
The first controller should have 6 disks, the second 4, and the last
2.
Thanks,
Ry
--
Finest handcrafted code since 1987.
<A HREF="http://www.wicker.com/">Ry's Pathetic Homepage</A>
Received on Sat Mar 02 1996 - 13:03:34 NZDT