I installed a Conner CS4000DT on my HP LC133...However, it shows up in
the boot up as "Python" scsi tape drive. There appears to be some sort
of conflict with the SCSI adapter which is adaptec 274x/284x/AIC777x.
It will fail each time during system start up no matter what driver I
use to run it. The stock NT program "Backup", sees a tape device but
says it has not been started etc.. and yet the NT setup shows no device
installed. I thought I should just go ahead and try and find a "python"
driver if possible, and Seagate/Conner seems to be of now use.
Any suggestions would be appreciated
__Cliff
Received on Tue Jul 16 1996 - 23:39:52 NZST