I have a Seagate ST12550N 2Gb disk I wish to install in a DEC 2100A.
Are there any special jumper settings I need to set, other than SCSI ID,
to use the drive with my machine?
Which disktab definition do I need to specify?
I plan to install the new disk on the same SCSI bus as the internal
CD-ROM and floppy drive. I'm pretty sure the SCSI ID for the CD-ROM is
6. What is the SCSI ID for the floppy?
I am planning to use the entire disk as a swap device.
My understanding of the installation procedure (assuming installation
for device rz5) is as follows:
1. cd /dev
2. MAKEDEV rz5
3. disklabel -rw rz5 <some disktab definition>
4. edit /etc/fstab with an entry like "/dev/rz5c swap2 ufs sw 0
2"
Is this correct?
Thanks in advance.
Received on Tue Apr 29 1997 - 02:31:13 NZST