Hello Everyone
Thanks for all the suggestions I received from this group.
Everyone basically said the same thing that they had
already connected a BA35* to a PMAZC-AA SCSI
turbo controller inside a DEC 3000/600S running UNIX 3.2d.
SETUP
-----
Once the PMAZC-AA has been installed and configured into
your server, you can then connect the BA350 to one of the
two SCSI channels. Then using the documentation
provided you can issue some basic commands to view and
configure the PMAZC-AA card from the console prompt.
e.g >>>> t tc0 cnfg
The command above examines the PMAZC-AA card on SCSI 0 and
displays some information about what is attatched to this
card.
Once the drives are showing up, then you can treat them as
you would any new disk and rebuild the kernel. See "Booting
from GENVMUNIX and rebuilding a kernel" in you UNIX
documentation.
MANY THANKS TO:
---------------
Dr. Thomas P. Blinn, UNIX Software Group, Digital Equipment Corporation
"Alan Rollow" <alan_at_nabeth.cxo.dec.com>
jason andrade <jason_at_dstc.edu.au>
Erik Persson <erik_at_lysator.liu.se>
Regards
Chris Glenister
-----------------------------------------------------
C.Glenister
Computer Systems and Network Manager
School of Agriculture, Food and Environment
Cranfield University
Silsoe
Bedford. MK45 4DT Tel: +44(0)1525 863027
E-mail: C.Glenister_at_cranfield.ac.uk
Web Server
http://www.silsoe.cranfield.ac.uk
-----------------------------------------------------
Received on Mon Jun 23 1997 - 10:22:13 NZST