Thanks to Damian McGuckin for his quick reply. Turns out that I really
needed to be using the serial term as a console (i.e. set console
serial) instead of just leaving console set to graphic.
On Wed, 26 May 1999 13:29:53 CDT dbongert_at_ssc.wisc.edu wrote:
>
> Anyway, I have the Firmware Update v.5.3 cd in the drive, and the
> system comes up to the firmware prompt OK. I type 'boot dka400', and
> the system starts to boot. It gets to "Jumping to bootstrap code" and
> hangs...all disk activity stops, and I can't get any response from the
> system. I've tried booting from a firmware upgrade diskette I made
> with mkbootfirm (with the firmware image from the CD on another DU
> system), and I've tried booting from the 4.0e install CD, with the
> same results.
Dan Bongert dbongert_at_ssc.wisc.edu
SSCC Unix System Administrator (608) 262-9857
Received on Wed May 26 1999 - 18:52:14 NZST