Upgrade to 4.0E crashes DEC3000 when starting X

From: Hellebø Knut <Knut.Hellebo_at_nho.hydro.com>
Date: Wed, 02 Jun 1999 17:27:04 +0200

Regards,

I recently performed an upgrade on some older DEC3000 systems. Two of
them crashes consistently when X starts. These two have PMAGC-BA cards
and crashes with the message

pv: can't continue from PV TLB Miss

Relevant data:

pv0 at tc0 slot 2
pv0: vram=8MP, ua=4x4, vp=1280x1024, pms=32KP, pmc=256, id=PMAGC-BA
DEC 3000 - M600 system
Firmware revision: 7.0

Booting genvmunix is OK. I am not able to see any significant
differences when generating a new kernel config file by doing a 'sizer
-n' command either. So I suspect either Open3D or the OSFSERTC435 (X
servers for Turbochannel) to be contaminated.

Luckily, X startup isn't crucial for the users so I have circumvented
the problem by setting XLOGIN="none" in /etc/rc.config.

Anyone seen this before and is able to guide me in the right direction
??

-- 
      ******************************************************************
      *         Knut Hellebø                     | DAMN GOOD COFFEE !! *
      *         Norsk Hydro asa                  | (and hot too)       *
      * Phone: +47 55 996870, Fax: +47 55 996495 |                     *
      * Cellular Phone: +47 93092402             |                     *
      * E-mail: Knut.Hellebo_at_nho.hydro.com       | Dale Cooper, FBI    *
      ******************************************************************

Received on Wed Jun 02 1999 - 15:29:28 NZST