I would like to know whether it is possible to configure X.25 so that
an outgoing call can address a listening party on the same system as
the originator without going to an X.25 network.
Currently I have configured two systems each with an LLC2 DTE that
addresses the other system and I am using X.25 Relay Clients for
sending X.25 packets back to the originating system. This
configuration is a bit clumpsy and requires an extra system. I would
like to configure an LLC2 DTE specifying the MAC address of the local
system, but in this case calls are being rejected with error 53
"Software caused connection abort".
Any ideas
Finn Andresen
Received on Fri Sep 10 1999 - 11:46:13 NZST