Greetings Managers
The scenario is :
Alphaserver ES40
Tru64 V4.0F
2 x 18Gb internal disks.
The two internal (boot) disks DKA0 (rz0) and DKA100 (rz1) have been mirrored
using LSM
- volencap rz0
- volrootmir -a rz1 (after various modifications to the rz1 disklabel)
Everything was happy until a recent shutdown/power-off. After power on,
error message on console stating that dka0 disabled via run/stop switch.
Tried booting dka0 - no joy. Booted dka100 but problems further into the
boot SCSI CAM errors. Removed DKA0 from system and booted DKA100 no problem.
The question is : What is the cleanest way of replacing DKA0 (rz0) back into
LSM control. The LSM manual is not exactly clear !!
LSM does seem extremely complicated to configure/modify - hardware RAID
controllers would be my first choice everytime !!
Many thanks in advance
Kevin Jones
-------------------------------------------------------------------
Standard Email disclaimer follows for legal reasons....
The information in this e-mail is confidential and is intended for the
addressee only. Copying or use by anybody else is not authorised. Its
content does not necessarily represent the opinion of Hamilton Rentals
PLC (part of the Compel Group) or any of its affiliates. If you are not
the intended recipient, please advise the sender by return e-mail.
This email was scanned for over 40,000 known viruses by
kerberos.hamilton.co.uk. It was deemed clean for transmission.
--------------------------------------------------------------------
Received on Thu Jan 20 2000 - 22:46:02 NZDT