Original message attached at the end of this summary.....
I had a number of responses the most useful of which was as foloows:-
The inquire command that is supposed to autodetect, doesn't! select 3
instead and when asked for device address enter "scsidev_at_2.0.0" (this would
be if the TL800 is on SCSI bus 2 at unit 0). If you're not sure which SCSI
address the TL800 is at run "scu show edt" which will list your devices and
where they are). If this wasn't clear, contact me and I will send you
detailed procedures.
Jef H. HamLin
..... and the most curious of which was:-
Install Networker 5.5.1-001 patch from the Legato web site.
There were some issues with scsi inquire an TL800 that are addressed in this
patch.
Steve Hagan
Compaq
I say curious because it was after I installed patch 5.5.1.001 that all my
hassles
began, ie. my index's and *.res files vanished when I issued the
"nsr_shutdown" command
and restarted with "networker.start".... this led me to go back to 5.5.1, at
least
the reason the scsi inquire not working is explained.....
In any case thanks so much to all who answered.....
Regards,
Leo
> -----Original Message-----
> From: Leo Kliger
> Sent: Tuesday, 21 March 2000 8:07:AM
> To: 'tru64-unix-managers_at_ornl.gov'
> Subject:
>
>
> Hello Managers,
> I am having problems with Legato Networker which I think I
> finally have
> under control except for one detail. When I use my existing
> *.res files
> then the database starts up but the software can't access my
> Juke box....
> When I use the original *.res files and run jb_config I get
> the following:-
>
> dip01/nsr/logs# jb_config
> 1) Install a SmartMedia Jukebox.
> 2) Install an Autodetected SCSI Jukebox.
> 3) Install an SJI Jukebox.
> 4) Install an STL Silo.
>
> What kind of Jukebox are you installing? [1] 2
> I didn't find any SCSI jukeboxes attached to this system.
> Perhaps you haven't connected any yet. Please re-run this
> program when you have connected the SCSI jukebox you want
> to install and have rebooted your system (if necessary) so
> that it may be seen
> dip01/nsr/logs#
>
> I would like to get it going without having to reboot my system.....
> I have tried reseting the SCSI bus and the Tape Device istelf.....
> Does anyone have any other ideas which don't involve the rebooting
> of the system?
>
> BTW here is the device info from the scu prompt:-
> Device: TL800 Bus: 2, Target: 0, Lun: 0, Type: Medium Changer
> Device: TZ89 Bus: 2, Target: 4, Lun: 0, Type:
> Sequential Access
>
> Thanks in advance,
> Leo
>
___________________________________________________________
PRIVATE AND CONFIDENTIAL
This email and any files transmitted with it are confidential and intended
solely for the use of the individual or entity to whom they are addressed.
If you are not the intended recipient you are hereby notified that any
dissemination, distribution or copying of this email is strictly prohibited.
If you have received this email in error please disregard the contents
of the email, delete the email and notify the author immediately.
Thank you.
Received on Tue Mar 21 2000 - 22:27:37 NZST