To: "Tru 64 Unix Sysadmins"
Hi all--
This is a small one, but it has me at wits end.
We just took delivery of an ES40 and I am having a strange problem
when I try to run the RCU to configure a SWXCR in the system. I am
using the RMC port, which is new to me and really seems like a nice
feature. However, when running the RCU program, I am not able to
get the config to save! I need to hit a Tab key to move to the 'yes,
I want to save the config' option, but I can't seem to get there
from here. I tried running through the console port (COM1) and various
other guesses, but the same problem comes up every time. The port seems
to treat all keystrokes as 'Enter', but only here as far as I can tell--
the Tab key works normally elsewhere.
The com1_mode param is currently set to THROUGH (the factory default),
and I suspect this is one place where the problem could be occurring,
but it's not obvious from the docs what it should be set to instead.
I was planning to open a call with Compaq tomorrow, but if someone
has seen this and could give me some guidance on it, I'd greatly
appreciate it.
Thanks as always--this list rules!
--Russ
Received on Sun Apr 23 2000 - 20:22:56 NZST