Hi!
I use the utility 'monitor' to look at system activity, especially disk
activity. However after upgrading our HSZ70s to HSG80s and connecting the
servers to a SAN, 'monitor' refuses to work. Instead I get one flash of
the usual "monitor-look" but with no values and I can capture an
error-message 'unable to read /dev/kmem'. However /dev/kmem have the same
permissions (440) as before the upgrade and monitor still has the s-bit
set for the mem-group so it doesn't feel like it is actually a
permission-problem. Anyone who has experienced this too? We're running
4.0F here and I have tried to recompile 'monitor' too but without any
effects.
/Eskil
+--------------------------------------------------------------------+
| |
| Eskil Swahn |
| LDC, Lund University |
| Email: Eskil.Swahn_at_LDC.lu.se Web:
http://www.ldc.lu.se/ |
| Phone: +46 46 222 4986 Fax: +46 46 138225 |
| |
+--------------------------------------------------------------------+
Received on Wed Aug 09 2000 - 11:06:03 NZST