I'm putting this request on hold until I can get time to get back out
and double check the two KZPBAs in one of the servers. I've got a hunch
that I pulled the wrong one (old one on a Y-cable arrangement) and not the
new one I had installed.
Sorry about that. I'll respond later.
Wayne
> -----Original Message-----
> From: Randy Rodgers [SMTP:randy.rodgers_at_ci.ft-wayne.in.us]
> Sent: Monday, September 11, 2000 12:28 PM
> To: Sweatt, Wayne
> Subject: Re: How do I get the SIPs for KZPBA-CB cards?
>
> When we got our KZPBA-CBs the terminators were in place in
> RM1-RM8.
>
>
>
> On 11 Sep 2000, at 12:19, Sweatt, Wayne wrote:
>
> >
> > We have received two KZPBA-CB UW-SCSI/PCI host adpater cards
> > and a DWZZH-03 USCSI Hub for use in a new TruCluster ASE.
> > I planned to use the hub ( as recommended ) and on-board termination
> > on the KZPBA. The termination is in the form of 8 resistor SIPs that
> > are plugged in receptors RM1 - RM8.
> > Where the heck are these things?
> > The KZPBAs came without them.
> > What is going on here? Don't tell me they're a separate purchase item!
> > Can anybody that has been here enlighten me on these resistors?
> >
> > Thanks,
> > Wayne
> >
>
>
> [=================================
> [ Randy Rodgers
> [ rrodgers_at_ci.ft-wayne.in.us
> [ Senior Systems Programmer
> [ Allen County/City of Fort Wayne
> [ Information Systems
> [ (219)427-5727
> [=================================
Received on Mon Sep 11 2000 - 19:02:55 NZST