Hi,
I am responsible for AS4100 cluster. When I received the cluster, one
component had its console switched to serial mode. I tried the normal way of
swithing it back with "set console graphics" & "init" but that didn't work.
I the tried the cold boot after "set console graphics" but that didn't work
either. Then I upgraded the Firmware to V5.8 but that didn't do any good
either.
Anyone have an idea on how to fix this?
Thanks,
Joel
____________________________________________
Joel Vosu
Systems Engineer
Kungla Dialoog C. P.
mailto:joel_at_kungla.ee
GSM: +372 51 83778
____________________________________________
Received on Fri Nov 17 2000 - 06:02:27 NZDT