Hi,
I want to add a 2nd trio64 1Mb graphics card to a 4100 but am not having
much luck.
Server spec:
AS4100 EV5/300 512Mb fresh install of 4.0F, no additional software /
patches installed. Console 5.8-2.
pci0 slot 4 = trio vga
pci1 slot 2 = ethernet
pci1 slot 3 = scsi
pci1 slot 4 = fddi
The above is fine, but I tried adding the new card (same as original
card) in pci1 slot 5 and that seemed to be OK in that I could do a sh
config to see it at the console. However, though I could boot off
vmunix, booting off genvmunix caused a crash ("Machine Check Processor
fatal abort").
Any suggestions?
Regards & thanks in advance,
Tony.
P.S. I checked out the new card in place of the original and it's OK.
P.P.S. Apologies if you've already seen this, but I sent it 45 mins ago
and haven't seen it posted yet.
Received on Fri Jan 05 2001 - 11:30:01 NZDT