Hello,
What's the status of Adaptec AHA-2940 SCSI support for Tru64? Apparently
Tru64 5.1 supports Adaptec controller chips with the aha_chim.mod driver.
For testing, I've plugged an AHA-2940 into our PC164LX based machine. The
latest SRM console firmware version 5.8 sees the Adaptec controller and
the disk just fine. I can even boot from the disk! Of course there's no
operating system on it yet.
For further testing, I've booted the V5.1 installation CD but I get a
message similar to this:
PCI device at bus 0, slot 6, function 0 could not be configured:
Vendor ID 0x9004, Device ID 0x8178, Base class 0x1, Sub class 0x0
Sub-VID 0x0 Sub-DID 0x0 has no matching entry in the PCI option table
and I can't see the disk in the disk selection dialog.
Apparently the Adaptec support in Tru64 is limited to the on-board
controller for DS20 and UP2000 machines. Is this true? Any trick to get
AHA-2940's running anyway? Where are all the entries in /etc/sysconfigtab
gone in Tru64 5.1 where it was possible to assign a specific PCI device id
to a driver module?
Thanks // Tom
--
--------------------------------------------------------------------------
Dr. Tom Leitner Dept. of Communications
Graz University of Technology,
e-mail : tom_at_radar.tu-graz.ac.at Inffeldgasse 12
Phone : +43-316-873-7455 A-8010 Graz / Austria / Europe
Fax : +43-316-463-697
Home page : http://www.radar.tugraz.at/people/tom.html
PGP public key on : ftp://wiis.tu-graz.ac.at/pgp-keys/tom.asc or send
mail with subject "get Thomas Leitner" to pgp-public-keys_at_keys.pgp.net
--------------------------------------------------------------------------
Before we have the paperless office, we have the paperless toilet!
Received on Mon Mar 05 2001 - 08:39:05 NZDT