Sorry for what's probably a trivial question, but I'm stuck.
After upgrading the firmware, I booted the 5.1 Operating system
disk. It couldn't start up the X-server, and I finished the
installation in the non-gui mode. Anyone run into this too
and figure out a way to get it to work?
In very old releases of Digital Unix, you'd have to install
Open3d before the system could use this device, but then
for many releases (I think 4.0 through 4.0f) it just worked.
I tried installing Open3d from the 4.0f CDs, but setld would
let it, and I couldn't find an Open3d on the 5.1 CDs.
Received on Fri Apr 13 2001 - 13:27:38 NZST