I have an RZ29B-W that was working in an AlphaStation 500/500 until we
temporarily added a second one to the bus. At this point the original one
stopped working, even after removing the second one, so the configuration
was the same as before we touched it. There were no conflicting IDs
between devices or the controller itself, and termination is correct.
Its in the same state as it was before we added the other disk.
It no longer shows up in show dev, but the LED on the front of the RZ29B-W
flashes in a continous pattern that repeats itself after a long pause:
-...--..
- being a long flash, and . being a short flash
I don't have any documentation that describes how to interpret the
LED. Does anyone have any such documentation?
Thanks,
Tom
Received on Thu Jun 07 2001 - 20:14:49 NZST