All
I now have a slight problem with my AXP 150 after updating the firmware.
Basically it wont boot and just goes into a boot crash loop.
I am hoping all I need to do is run the EISA Config Utilities from the ECU
disk.
Unfortunantly I dont have one , If someone could point me to one or be as
kind to mail me one that would be great.
On the other hand any other ideas as to how I have knackered my box would be
appreciated.
Cheers
Hugh
axp_at_hughtrevelyan.co.uk
NOTICE AND DISCLAIMER:
This email (including attachments) is confidential. If you have received
this email in error please notify the sender immediately and delete this
email from your system without copying or disseminating it or placing any
reliance upon its contents. We cannot accept liability for any breaches of
confidence arising through use of email. Any opinions expressed in this
email (including attachments) are those of the author and do not necessarily
reflect our opinions. We will not accept responsibility for any commitments
made by our employees outside the scope of our business. We do not warrant
the accuracy or completeness of such information.
Received on Mon Jul 23 2001 - 09:58:33 NZST