Hi All,
We are converting our single controller HSG80 to dual controllers,
and in reading through the documentation, I noticed that the command
CONFIG SAVE cannot be used in a dual redundant configuration. What
happens if we need to rebuild this system from scratch? Do we have
to write down the config on paper and type it all in again? What
disaster recovery of the configuration is available with dual
controllers?
--
Bob Sloane, University of Kansas Computer Center, Lawrence, KS, 66045
sloane_at_ukans.edu http://www.ukans.edu/home/sloane Phone:(785)864-0444
Received on Fri Oct 19 2001 - 19:25:53 NZDT