Hi managers,
We are using several T64 v5.1 systems connected with HSG/HSZ controllers in
multi bus failover mode.
When looking at the disks (with hwmgr) you see several valid paths to a
certain disk. As far as I know only one path to a certain disk is used at
any time. When the primary path to a disk is gone, the system will fail over
the traffic to another valid path. The system takes the first path that it
sees as the default valid path. Is there any way to change this in order to
use different default paths to make sure the load is equally divided over
all existing paths. In other words we would like to know if there is a
possibility to change the "First valid path" column in the "hwmgr -show scsi
-id xxx" command to another path.
Regards,
Gert-Jan Hilbrands
------------------------------------------------
Atos Origin Telco Services, Unix support
050-5882781 / 06-51584767
gert-jan.hilbrands_at_atosorigin.com
Received on Mon Oct 29 2001 - 12:36:40 NZDT