Boot Hang on Alphaserver 4100

From: McCalla, Wesley <wesley.mccalla_at_guardianit.com>
Date: Wed, 20 Mar 2002 16:48:04 +0000

> Hello Managers
>
> I hope someone out there can help? We are trying to recover a Tru64 Unix
> system from an ES40 onto an Alphaserver 4100. The system had AdvFS
> encapsulated within LSM. We've omitted all references in /etc/inittab with
> reference to LSM and recovered all data on AdvFS filesets. Also all
> relevant files within /etc and /dev connected with ES40 hardware have been
> deleted from the root partition.
>
> The idea was to boot the system into single-user mode on our target disk
> on the Alphaserver 4100 using the generic kernel and carry on the
> re-configuration from there. However on boot up the display then hangs at
> the following point....
> .
> .
> .
> Created FRU table binary error log packet
> kernel console: ace0
> NetRAIN configured
> i2c: Server Management Hardware Present
>
> vm_swap_init: warning /dev/rz24b swap device not found
> vm_swap_init: swap set to lazy (over-commitment) mode
>
>
>
>
>
>
>
>
>
> Any suggestions or solutions would be greatly appreciated. Many thanks in
> advance.
>
> Regards
>
>
> Wesley McCalla
>


www.guardianit.com

The information contained in this email is confidential and intended
only for the use of the individual or entity named above. If the reader
of this message is not the intended recipient, you are hereby notified
that any dissemination, distribution, or copying of this communication
is strictly prohibited. Guardian iT Group will accept no responsibility
or liability in respect to this email other than to the addressee. If you
have received this communication in error, please notify us
immediately via email: postmaster_at_guardianit.com


_____________________________________________________________________
This message has been checked for all known viruses by MessageLabs Virus Control Centre.
Received on Wed Mar 20 2002 - 16:48:19 NZST

This archive was generated by hypermail 2.4.0 : Wed Nov 08 2023 - 11:53:43 NZDT