Greetings,
I have a DS20E with a KZPCC controller, currently running Tru64 UNIX 5.1A PK3.
Firmware is the latest.
While attempting to upgrade to Tru64 UNIX 5.1B the following message was
displayed indicating the hardware (about 5 months old) is not supported in the
new release. Any ideas why? I have succesfully installed 5.1B on several
other machines that are 4 or 5 years old.
*** START UPDATE INSTALLATION (Mon Mar 3 14:52:31 EST 2003) ***
FLAGS:
Checking for retired hardware...done.
The following hardware has been detected on your system. The update
installation process has determined that this hardware is not
supported in the new release (Compaq Computer Corporation Tru64 UNIX
V5.1B). If you continue with the update installation this hardware
will no longer function once the operating system has been updated.
The loss of this hardware may make the system unusable. It is
recommended that you do not continue with the update installation.
i
For further information on retired hardware see the Release Notes for
Compaq Computer Corporation Tru64 UNIX V5.1B.
Do you want to continue the Update Installation? (y/n) [n]: n
Returning system to Pre-Update state...done.
Exiting Update Installation...
Removing temporary update installation files...done.
A log of the Update Installation has been recorded in the file
/var/adm/smlogs/update.log.
*** END UPDATE INSTALLATION (Mon Mar 3 14:53:15 EST 2003) ***
Received on Tue Mar 04 2003 - 10:19:09 NZDT