I have to add the following lines to /sys/conf/<HOSTNAME>
bus i2o0 at *
controller i2o_bs0 at i2o0 slot 0
device disk ri0 at i2o_bs0 drive 0
controller i2o_bs1 at i2o0 slot 0
device disk ri1 at i2o_bs1 drive 1
config_driver pza
and rebuild a new kernel with
# doconfig -c <HOSTNAME>
Copy it to / and reboot.
Many thanks for all replies.
>Betreff: Problem with DS-KZPCC-AC and ES40/Tru64 5.1B-PK3
>
>Hi Managers,
>
>we have an ES40 (2 x 833Mhz) with 4 GB Ram, Tru64 5.1B-PK3, Alpha Firmware 6.6-19. I installed a DS-KZPCC-AC (Firmware CQ17) and connected it to the internal drive cage DS-610-6D. The 3 x HP 72 GB 10k Hotplug SCSI Drives are configured as a RAIS 5. But neither in /devices/disk nor in the disk-app in CDE are entries of the RAID-Volume.
>
>On console the volume and the controller are shown as follows:
>
>dza517.0.0.2004.1 DZA517 (BSA)
>pza0.0.0.2004.1 I2OA0
>
>
>Any ideas why the volume doesn't appear? Normally dsfmgr have to create the /dev entries at boot time, right? TIA.
>
>
>Best regards,
>Thomas Hummel
>
Received on Tue Sep 27 2005 - 11:59:03 NZST