$ PRODUCT INSTALL JDECW /source= DKA400:[JDECWAXP016.KIT]
The following product has been selected:
DEC AXPVMS JDECW V1.6 Layered Product
Do you want to continue? [YES]
Configuration phase starting ...
You will be asked to choose options, if any, for each selected product and for
any products that may be installed to satisfy software dependency requirements.
DEC AXPVMS JDECW V1.6 : DECwindows Motif/Japanese
Copyright 2006 Hewlett-Packard Development Company, L.P.
Hewlett-Packard Company
This product uses the PAK: DW-MOTIF and DW-MOTIF-UI-JAPANESE
Do you want the defaults for all options? [YES] yes
Do you want to review the options? [NO] yes
DEC AXPVMS JDECW V1.6 : DECwindows Motif/Japanese
Do you need to install Japanese keymaps?: YES
Do you need to install 100dpi Japanese font?: YES
Do you need to install 75dpi Japanese font?: YES
Are you satisfied with these options? [YES]
Execution phase starting ...
The following product will be installed to destination:
DEC AXPVMS JDECW V1.6 DISK$1:[VMS$COMMON.]
Portion done: 0%...10%...20%...30%...40%...50%...60%...70%...80%...90%...100
The following product has been installed:
DEC AXPVMS JDECW V1.6 Layered Product
DEC AXPVMS JDECW V1.6 : DECwindows Motif/Japanese
This product requires the following SYSGEN parameters:
GBLPAGES add 13300
This product requires the following SYSGEN parameters:
GBLSECTIONS add 40
Installation Verification Procedure (IVP) can be run after reboot.
The IVP is SYS$TEST:DECW$IVP_JA_JP.COM.
Installation of DECwindows Motif/Japanese for OpenVMS Alpha completed.
Check whether this product have the following PAKs registerd and loaded.
PAK Name
DW-MOTIF
DW-MOTIF-UI-JAPANESE
These are required to run any DECwindows Motif/Japanese for OpenVMS
application.
If your system is already running DECwindows Motif, restart DECwindows
Motif with the following DCL command:
$ @SYS$MANAGER:DECW$STARTUP RESTART
If your system has not run DECwindows Motif yet, start DECwindows
Motif with the following DCL command:
$ @SYS$MANAGER:DECW$STARTUP
$
|
