The command "scu scan edt bus 0" and "scu show edt |
fgrep -v present" showed the new 2nd SCSI drive on target 6.
After using MAKEDEV rz6 and then disklabel to repartition
the drive, it disappeared on reboot. At the boot prompt,
"show config" recognizes it, but SCU no longer does. Any
ideas?
PS. I could find any recommendations in the documentation
for partitioning a second drive. We want to add about 200 MB
of secondary swap (on b) with the remainder in a home
partition (on h). I consider this a standard use for a second
drive, but could not find any reference in documentation of in
FAQ's. I have heard that we need to leave a filesystem on a
for the disk label, but cannot find out how little is enough.
Received on Thu Aug 15 1996 - 17:29:42 NZST