According to the Owner's Guide, for a single-controller configuration, "to
make StorageWorks slot 5 available, the tape drive must be disconnected".
On two other pages, it says "you must disable the tape drive". I do not
have an internal tape drive, yet slot 5 is unusable. If I put a
StorageWorks device in slot 5, it does not show up. I am able to use slots
0 thru 3 and 6 (4 is used by the CDROM). Since I can access slot 6, I
assume that jumper W1 is properly enabled.
How do I "disable the tape drive" ?
Ray Keller
Williams International
Walled Lake, Michigan
RKeller_at_williams-int.com
Received on Mon Oct 21 1996 - 23:36:45 NZDT