I just installed a KZPBA-CA UW Controller card in my AlphaServer 4000.
It has a DS-BA356-series Storage Works shelf attached to it.
When the system boots it finds the controller card and polls it
but finds nothing on the bus (I have a DS-RZ1DF-VW in the shelf).
Obviously 'scu' produces nothing at the OS level.
I have tried a number of different dip switch settings on the I/O
module (Which is a 16 bit module with the fancy new UW connector
types). I have gone through the manuals but I must admit that I can't
quite figure out whether blacks means on or off in the graphs the show.
Unfortunately, I couldn't find anywhere in the manual where it points
this out. The cable also looks like it is good condition.
Thanks for your help!
-Dan
--
----------------------------------------------------------------------
Daniel David Benson bensond_at_ucdavis.edu
System Administrator http://wwwcsif.cs.ucdavis.edu/~bensond
Social Science Data Service pgp - finger bensond_at_aion.ucdavis.edu
University of California, Davis Linux User
----------------------------------------------------------------------
Received on Sun Oct 11 1998 - 19:45:23 NZDT