HI All ,
Thanks to all the people who wrote and phoned ! .
I finally got a couple of engineers from Digital over
who basically wanted to have a good long play with
the HSZ22 & SWCC . Basically the deal is :
To upgrade to 2 controllers , you have to insert the first
controller , and backup its configuration to the PC .
You then remove the first controller and put the second
one in the top slot. You then restore the config from the PC .
Then you can put the original controller in the bottom slot .
The fact of the second controller being greyed out on the
SWCC tcp/ip conection is correct .
What we found out was that if you failover a controller
with the PC SWCC GUI , you have to physically pop it
out and in to recover it , doing a restart from the GUI
doesn't work . Also if you refresh the GUI after
replacing the controller , it doesn't show the controllers
as going back to active/active . This is a bug , You have
to close the GUI down and re-open/connect it to get the
correct display .
You can connect a second kzpba adapter to the port
H1 if you want and select target 1 for naming some
other disks and use that for load sharing .
Thanking you ,
Gary Menna E-Mail g.menna_at_isu.usyd.edu.au
Information Technology Services Phone +61 2 9351-6360
University of Sydney (G05) Fax +61 2 9351-7711
*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*
* *
* When what is indestructible *
* Meets that which is irresistible . *
* The female always wins . *
* Monkey . *
*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*
Received on Tue Jul 27 1999 - 04:15:45 NZST