We have several esa10000's. One of them has the configuration stored
on the disks, as evidenced by "show device full", but the other, although
we are sure we initialized it to have the configuration stored on disk,but
it doesn't show up as there.
I have two questions.
1. How do you initialize with a save_configuration? Do you init the disks
this way, or the mirrorset, or the unit?
2. Is there a way to do a save_config to a mirrorset after the fact, if that
mirrorset is empty?
TIA.
--
Judith Reed
jreed_at_appliedtheory.com
(315) 453-2912 x5835
Received on Wed May 17 2000 - 08:43:49 NZST