Hello Managers
I have been requested to install a DEGPA into an ES40 running Tru64 V4.0F.
The docs that come with the card only refer to V4.0D. After some searching
of the web and archives of this forum, it appears that the drivers that were
supplied with the card are no longer required to be installed (via setld) as
they have been part of the operating system since V4.0E.
The question I have is around the configuration of this card into the
kernel.
The manual suggests booting genvmunix, doing a
sysconfig -c alt
doconfig
Other entries have suggested that it only requires the line
pseudo-device alt
to be added to the configuration file and then the kernel rebuilt. My
concern around this is that I have been shown a configuration file for a
system that already has a DEGPA and that has the line
config-driver alt
in its configuration file.
Can anyone please tell me the correct way of doing this.
Many thanks
Kevin Jones
email : mailto:kevin.jones_at_compelsolve.co.uk
-------------------------------------------------------------------
Standard Email disclaimer follows for legal reasons....
The information in this e-mail is confidential and is intended for the
addressee only. Copying or use by anybody else is not authorised. Its
content does not necessarily represent the opinion of Hamilton Rentals
PLC (part of the Compel Group) or any of its affiliates. If you are not
the intended recipient, please advise the sender by return e-mail.
This email was scanned for over 40,000 known viruses by
kerberos.hamilton.co.uk. It was deemed clean for transmission.
--------------------------------------------------------------------
Received on Tue Oct 10 2000 - 11:21:38 NZDT