Hello Again
Does anyone have any experience of configuring a fibre channel tape
controller II with Tru64 V4.0x.
I have configured one with V5.0a with no problem.
The configuration is : ES40 (KGPSA) -> Switch -> FC-TC II -> TL892 (with two
TZ89 drives)
The problem appears to be that the FC-TC II presents the tape drives within
the library with a non-zero LUN's.
On the TL891 the ID's are:
Robot Arm 0
Tape Drive 4
Tape Drive 5
Unix sees the robot arm but not the drives. Obviously Tru64 copes with
non-zero LUN disks by using the
rzx naming convention.
Are non-zero LUN tapes supported ?
Regards
Kevin Jones
email : mailto:kevin.jones_at_compelsolve.co.uk
-------------------------------------------------------------------
Standard Email disclaimer follows for legal reasons....
The information in this e-mail is confidential and is intended for the
addressee only. Copying or use by anybody else is not authorised. Its
content does not necessarily represent the opinion of Hamilton Rentals
PLC (part of the Compel Group) or any of its affiliates. If you are not
the intended recipient, please advise the sender by return e-mail.
This email was scanned by kerberos.hamilton.co.uk. It was deemed clean for transmission. Please be aware that all emails are subject to monitoring.
--------------------------------------------------------------------
Received on Tue Nov 14 2000 - 22:36:30 NZDT