Am trying to customize the disklabel on my system drive. I am trying
to do a full install of V5.1. So I ctrl-c, go fix the disklabel and
then do the "restart nogui". Keep getting the following result:
Continuing installation...
Restoring the existing disk label on device dsk0
The installation process has failed during an attempt to update the
disk label with new partition sizes. This error is fatal, and causes
the installation process to stop. The following error message was
returned from the "disklabel" command:
disklabel: ioctl DIOCWDINFO: No disk label on disk; use "disklabel
-wr"
to install initial label
#
I know it must be something extremely trivial staring at me in the
face and laughing hysterically but I can't figure it out. Any
suggestions, Puhlease?
Tks & Rgds,
Alay Shah
Allegiance Healthcare Corporation
1400 Waukegan Rd.
McGaw Park, IL 60085
Ph - 847-578-2584
Fax - 847-578-5586
Email - shahal_at_allegiance.net
Received on Fri Dec 01 2000 - 17:02:44 NZDT