The parameters no longer seem to exist (maxdsiz, maxssiz etc)
To prove this i did the following :-
# /sbin/sysconfig -s | cut -d ":" -f 1 > mjw - To get all subsystems
# for mike in `cat mjw`^Jdo /sbin/sysconfig -Q $mike^Jdone > fred - lists
all parameters to output file fred
# grep dsiz fred - returned nothing as did ssiz
Mike.
> -----Original Message-----
> From: Mike Whorley
> Sent: 06 December 2000 13:24
> To: 'tru64-unix-managers_at_ornl.gov'
> Subject: Config issues after upgrade to TU64 5.0
>
> All,
>
> I've just upgraded to Tru Unix 5.0 and was pleasantly surprised how
> painless it was.
>
> After the upgrade I noticed that some settings in my old kernel config
> file /usr/sys/conf/DENMARK.bck had not been included in the new file.
>
> These parameters were :-
>
> dfldsiz 1073741824
> maxdsiz 1073741824
> dflssiz 2097152
> maxssiz 33554432
>
> I edited the new DENMARK file and added them in the same place and ran
> doconfig.However It falls over with syntax error on the line with the 1st
> entry :-
>
> denmark.coda.com:/usr/sys/conf>/usr/sbin/doconfig -c DENMARK
>
> *** KERNEL CONFIGURATION AND BUILD PROCEDURE ***
>
> Saving /sys/conf/DENMARK as /sys/conf/DENMARK.bck
>
> Do you want to edit the configuration file? (y/n) [n]:
>
>
> *** PERFORMING KERNEL BUILD ***
>
> Configuration file has errors.
> config: line 59: syntax error
>
> Do you want to edit the configuration file? (y/n) [n]: n
>
> *** NOTE ***
> A new kernel for this machine could not be successfully created.
>
> Anyone know whats causing this ?
>
> Are these parameters no longer supported in this release of TU64 ?
>
> Regards,
> Mike.
>
>
> __________________________________
> Mike Whorley
> Systems Administrator
>
> CODA plc
> Cardale Park, Beckwith Head Road
> Harrogate, HG3 1RY, England
>
> Tel +44 (0)1423 509999
> Direct +44 (0)1423 537934
> Fax +44 (0)1423 537862
>
> email mike.whorley_at_coda.com
> web http://www.coda.com
> __________________________________
>
Received on Wed Dec 06 2000 - 14:59:12 NZDT