I'm in the process of making a cross-over cable. The pinouts I have.
I see that for 10BT there is only switching of 1,2,3, & 6
and for the 100BT 4,5,7 & 8 join in on the fun
Then I found a site that for a 10/100BT to use the 10BT pinout.
Is 4 5 7 8 used in 100BT? I'm going to be going from a 10/100BT
switched hub to a 10BT hub, the 10/100BT hub is an autosense but the 10BT
is strictly 10BT
Should I switch 4 5 7 & 8 or just switch 1,2,3 & 6 ?
Or is 4 5 7 & 8 for the half/full duplexing?
Oh, this is for a 2100 system running 3.2c
George Gallen
Senior Programmer/Analyst
Accounting/Data Division
ggallen_at_slackinc.com
ph:856.848.1000 Ext 220
SLACK Incorporated - An innovative information, education and management
company
http://www.slackinc.com
Received on Wed Dec 27 2000 - 19:16:28 NZDT