Hi gurus,
Problem: I'm trying to install a new SCSI card (Symbios SYM8952U) and
second SCSI hard drive in my Compaq XP1000 running Digital UNIX V4.0F.
Current status/questions:
- I've installed the SCSI card and only one (internal) device, my new
hard drive, to the new card.
- A "show device" at the boot (>>>) prompt is able to correctly see
the new SCSI controller and disk.
- Darn, I don't see the new disk (automatically) detected in the startup
message.
- How do I make a special device file for this new disk? Specifically,
how do I get the correct parameters for the MAKEDEV command (bus no,
etc)? How do I set options to have my kernal recognize the new disk?
I'm still at the sysadmin level where I need detailed explicit examples!
Thanks in advance for any help you can lend,
Chong.
+----------------------------------------------------------------------+
| Chong M. Cha Email: chongcha_at_stanford.edu |
| Center for Turbulence Research Tel: (650)725-6635 |
| Stanford University Fax: (650)723-9617 |
| Stanford, CA 94305-3030
http://www.stanford.edu/~chongcha |
+----------------------------------------------------------------------+
Received on Tue Jan 09 2001 - 22:46:17 NZDT