Hello
Having relocated a network card from one PCI slot to another, it now appears
as tu1 instead of tu0.
Is there a way of renaming back to tu0 ?
This is V5.1 patch kit 3.
I've had a try with some of the hwmgr -set ....... and sysman -cli set attr
.... commands. But these imply that it cannot be renamed. The trouble is
that the hwmgr command is very cumbersome and it is very difficult to work
out the precise switches to enable you to do anything.
Regards
Kevin Jones
-------------------------------------------------------------------
Standard Email disclaimer follows for legal reasons....
The information in this e-mail is confidential and is intended for the
addressee only. Copying or use by anybody else is not authorised. Its
content does not necessarily represent the opinion of Compel or any of its affiliates. If you are not
the intended recipient, please advise the sender by return e-mail.
This email was scanned by hades.hamilton.co.uk.
It was deemed clean for transmission.
Please be aware that all emails are subject to monitoring.
--------------------------------------------------------------------
Received on Fri Oct 26 2001 - 14:59:25 NZDT