Regulatory Information

Product Name: Iomega Zip® 100 Parallel Port drive
Model Number: Z100P2

FCC (United States)
The computer equipment described in this manual generates and uses radio frequency (RF) energy. If the equipment is not installed and operated in strict accordance with the manufacturer's instructions, interference to radio and television reception may result.

This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Part 15, Class B, of the FCC Rules, is designed to provide reasonable protection against radio and television interference in a residential installation. Although the equipment has been tested and found to comply with the allowed RF emission limits, as specified in the above cited Rules, there is no guarantee that interference will not occur in a particular installation. Interference can be determined by turning the equipment off and on while monitoring radio or television reception. The user may be able to eliminate any interference by implementing one or more of the following measures:

  • Reorient the affected device and/or its receiving antenna.

  • Increase the distance between the affected device and the computer equipment.

  • Plug the computer and its peripherals into a different branch circuit from that used by the affected device.

  • If necessary, consult an experienced radio/television technician for additional suggestions.

NOTE: Changes or modifications to the electronics or enclosure of this product must be expressly approved by Iomega; otherwise, the user's authority to operate this product may be voided by the FCC.

| top of page |

North America
In North America, this product is intended to be supplied with a UL-Listed and Canadian-certified Class 2 direct plug-in power unit, with a rated output of 5 Vdc, 1.0 A.

Canadian Verification
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations (ICES-003, Class B).

CE (European Community)
The Zip® 100MB Parallel Port drive conforms to the following European Directive(s) and Standard(s): Application of Council Directives: 73/23/EEC, 89/336/EEC. Standards to which Conformity is declared: EN60950, EN55022, EN50082-1. Importer's Name: Iomega Netherlands branch of Iomega International, S.A. Type of Equipment: Information Technology Equipment.

This is a Class B product based on the standard of the Voluntary Control Council for Interference from Information Technology Equipment (VCCI). If this is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual.

Manufacturer/Responsible Party
Iomega Corporation
1821 West Iomega Way
Roy, UT 84067 U.S.A.

| top | home | previous | next |


Copyright © 2000
Iomega Corporation
All rights reserved